Bnc 1105 Universal Counter Uživatelský manuál stáhnout pdf (Strana 151)

151

151151

151

 This command only applies when [:SENSe]:TOT:ARM[:STAR]:SOUR EXT is used.

[:SENSe]:TOTalize:ARM[:STARt]:SOURce IMMediate EXTerna

Sets or queries the starting point of the arm for Totalize measurement.

Return

 A sequence of ASCII-encoded bytes. IMM means Immediate and EXT means

External.

Notes

 This will be set to Immediate after the counter has been turned off or a remote

interface reset.

 When the staring and the stopping points are both set to immediate, the :INIT[:IMM]

command can be used to start totalizing and the :ABORt command can be used to

end it. Before the “auto” totalize measurement is terminated, there is no valid

totalize result.

[:SENSe]:TOTalize:ARM:STOP:SLOPe POSitive NEGative

Sets or queries the slope of the external stop arm signal used in external arming Totalize

measurements.

Return

 A sequence of ASCII-encoded bytes. POS means Positive and NEG means Negative.

Notes

 This will be set to Negative after the counter has been turned off or a remote interface

reset.

 This command only applies when [:SENSe]:TOT:ARM:STOP:SOUR EXT is used.

[:SENSe]:TOTalize:ARM:STOP:SOURce IMMediate TIMer EXTerna

Sets or queries the stopping point of the arm for Totalize measurements.

Return

 A sequence of ASCII-encoded bytes. IMM means Immediate, TIM means Timer and

EXT means External.

Notes

 This will be set to Timer after the counter has been turned off or a remote interface

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 196 197

Žádné komentáře

Bnc 1105 Universal Counter Uživatelský manuál Strana 151